CREATIVE ENGINEERS

Pumps are designed with integral conical tank to increase the palpability of frothy liquids. Conical tank with tangential inlet design work with hydro cyclone principal to separate air in the frothy liquids. This helps efficient pumping of frothy liquids higher capacity with long trouble free smooth operations sump with pump an motor are mounted on a floor, no special foundation, no alignment required.

Pumps has no gland box, submerged shaft seals or bearings. This eliminates requirement of sealing water, guarantees minimum maintenances. The bearings are fitted above the sump level with heaving double protection against penetration of slurry.

Wear parts are available with NI-HARD, HI-CHROME, NATURAL, RUBBER, CD4MCU, SS316, CF8M etc.

Capacity: upto 400 m3.hr
Head: 30 mts.
Discharge Size: 25 TO 200 MM.

Purpose Built For Frothy Suspensions
CREATIVE CONE PUMP IS DESIGNED TO INCREASE THE PUMPABILITY OF FROTHY SUPSPENSIONS. THE PRINCIPAL OF OPERATION IS PARTLY SIMILAR TO THAT OF CYCLONE SEPARATION. AIR IS SEPARATED FROM THE SLURRY IN A VORTEX CREATED BY THE IMPELLER ROTATION AND THE TANGENTIAL INLET TO THE PUMP’S CONICAL SUMP. THIS RESULTS IN A MORE EFFICIENT PUMPING AT HIGHER CAPACITIES AND SMOOTHER OPEATION.

Simple Installation
Because the pump, the sump and the motor are integrated to on unit, there is no leveling or special foundation required.

Stuffing Box
The pumps operate without stuffing box or other submerged shaft seals, which further simplifies maintenance and eliminates any requirement for seal water.

Bearings
The robust bearing assembly is fitted with grease-lubricated roller bearings. All bearings are rated for more than 60,000 running hours and are placed well above the slurry level.

Wear Parts
Standard wear parts are available in soft natural rubber or Ni-hard alloy. For special applications wear parts of silicon carbide or synthetic rubber are available. The design of the CREATIVE VERTICAL FROTH PUMPS allows combination of different wear part materials to be used in order to optimize the service life of the wear parts. The CVPF pumps have a built in raise and lowering mechanism for the pump casing to enable the wear parts to be easily accessible. The largest pump, however, requires an external lifting device.

CREATIVE HAS A LONG AND VARYING EXPERIENCE IN THE PUMPING OF FROTHY LIQUIDS. WITH OUR WIDE EQUIPMENT RANGE, WE CAN ASSIST IN SOLVING YOUR PARTICULAR PUMPING PROBLEM.