CREATIVE ENGINEERS

Creative Vertical Slurry Pumps are widely used in spillage applications in beneficiation plants.

These pumps have no glandbox, submerged shaft seals or bearing. This eliminates requirement of sealing water, guarantees minimum maintenance. The bearing are fitted above the sump level with heaving double protection against penetration of slurry.

Wear parts are available with Ni-hard, Hi-chrome, natural rubber, CD4MCU, SS316, CF8M etc.

CREATIVE SUMP PUMPS are available in various types.

Type-I: standard pump with closed impeller and extended suction (inlet).

Type-II: pump with spray hole casing, semi open impeller, spray holed in the casing helps part of slurry pumping back to the sump to agitates settled solids in the sump.

Type-III: pump with agitator.

Agitator is attached to the extended shaft, which helps to agitate course solids settled in the sump. More suitable for pumping course rapid settling solid setting solids like iron ore, coal, gold, chromite ore, etc.

Capacity: 5-600 m3.hr
Head: 6-55mts.
Discharge Size: 25 TO 200MM.
Frame size: 40,60,80,120,150,180,220cms

creativer sump pumps are designed for abrasive slurry service and feature simple maintenance and robust construction

Simple Installation
The larger units are normally bolted to a permanent baseplate, Free suspension in the sump by the lifting yoke is preferred for the smaller pumps. Both shaft bearings are located in a cylinder which is normally located above the baseplate for accessibility and protection. Special designs giving extended length with the basplate above the bearing are available on request

CREATIVE PUMPS can also supplies a series of submersible pumps with pumping elements from the CVP range.

Cantilever Design
The CVP pumps have no stuffing box, submerged shaft seals or bearings. This guarantees minimum maintenance and eliminates any requirement for sealing or flushing water.

Bearing Assembly
A rigid shaft is fitted with roller bearings for 70.000 hours minimum life. Impeller clearance is maintained by external axial adjustment of the shaft and bearing housing assembly, the bearings have double protection against penetration of slurry.

Wear Parts
Standard pumps are normally supplied with parts in transfer moulded natural rubber, high chromium iron or Ni-hard alloy. Other materials such as synthetic rubbers, polyurethanes and stainless and stainless steels are also available for most pump sizes. Wear parts in different materials are fully interchangeable. For selection of the optimum pump type and combination of materials, contact creative engineers.

CREATIVE SUMP PUMPS Are Available In Several Basic Types

Type-ISemi-open impeller and pump casing with spray holes (type “S”). Part of the pumped slurry is returned to the sump. This not only agitates so-lids in the sumps but also de-aerates the pumps to prevent air blocking.

Type-IIClosed impeller and flanged pump inlet which allows fitting of an extended suction pipe to increase the pump working depth.

Type-IIISemi- open impeller with extended shaft and slurry agitator (type “A”). This design is particularly suited for coarse, rapid settling solids.